The CV97 is a full length Chevy V6 header that fits very tight to the block and works with either side or front engine mounts and all steering setups. The CV97 fits all transmission and starter combinations. Comes with all hardware necessary for installation. Features a 16-Gauge primary and collector tube thickness, 3/8" thick flange, patented flange design requires NO gaskets, tightest fitting header available anywhere. Made in the USA. Also includes the header bolt set. Our Aluminized Ceramic Coating is available and RECOMMENDED on all Sanderson Headers. We apply a multi-layer inside and outside silver ceramic coating in-house to meet our high standards of quality, and polish the coated header to a high luster. This coating provides aerospace and military technology to your vehicle to control the heat in your engine bay, improve cylinder scavenging of exhaust gases, and increase the longevity of your header investment. Copper Collector Gaskets are recommended for all Sanderson headers. Sanderson Headers do not include collector bolts due to our customers' wide range of preference. We do offer a collector bolt set that features Grade 8 Bolts with Locking Nuts. The Patented Leak-Free Design that Sanderson Headers offer you is the only leak-free flange design on the market ... Do Not Attempt To Use Flange Gaskets! The raised flange on the Sanderson Headers will buckle the gasket during tightening and actually cause a leak! Sanderson Headers are NOT emissions legal on pollution-controlled motor vehicles. It is the purchaser's responsibility to verify local regulations for compliance. Wrapping your Sanderson Headers with ANY thermal tape voids your header warranty. The best thermal protection for your headers is our Aluminized Ceramic Coating that is available for every Sanderson Header. Limited 5-year warranty.
This part fits most Chevy Cars and Trucks.; exceptions may apply. Please read the complete description to see if this part fits your specific vehicle and application.